Operating the Fido X4
5 Operating the Fido X4
5.1 Fido X4 Power On Sequence
Before powering on the Fido X4, ensure that a charged battery has been properly installed,
and that all hardware components, such as the detector inlet and thermal desorber are con-
nected. Also, ensure that a sensing element is installed in the system.
5.1.1 Startup
To turn on the Fido X4, press and hold the power button, releasing when the display back-
light becomes visible, which takes about three seconds. After several seconds, the first of
several FLIR splash screens will appear. The startup process takes less than 30 seconds.
Figure 5-1:Startup screen
5.1.2 Heating Up
After completing startup, the Fido X4 will heat the internal components. This process typ-
ically takes around three minutes but will vary somewhat based on the ambient temperature.
Figure 5-2: Heating Up screen
30 4226044 (Rev. C) © 2020 FLIR Systems, Inc.
To Next Page
Loading...