FLIR Fido X4 - Figure 5-22: Vapor Mode Inlet Adapter; Figure 5-23: Presenting the Vapor Mode Inlet Adapter; Figure 5-24: Preparing to Verify Screen in Vapor Detection Mode

4226044 (Rev. C) © 2020 FLIR Systems, Inc.
41
FLIR Fido® X4 Operations Manual
Figure 5-22: Vapor Mode inlet adapter
Step 2: Press the uncapped end of the inlet adapter against the exposed tip of the
Detector inlet as shown in Figure 5-23.
Figure 5-23: Presenting the Vapor Mode inlet adapter
Step 3: Select Go to begin verification. A countdown of 3 seconds will display, then a
screen similar to Figure 5-24 will appear:
Figure 5-24: Preparing to Verify screen in Vapor Detection Mode