Operation
11
Follow this procedure:
1. Aim the camera toward an object of interest.
2. Depending on the Trigger button setting in FLIR Tools, do one of the following to start
the recording:
• With the Rec. on/off setting, pull the trigger.
• With the Record video setting, pull and hold the trigger.
3. A blinking circle in the middle left part of the screen indicates that the camera is cur-
rently recording a video clip.
4. Depending on the Trigger button setting in FLIR Tools, do one of the following to stop
the recording:
• With the Rec. on/off setting, pull the trigger.
• With the Record video setting, release the trigger.
11.6 Continuous video recording (FLIR K53)
11.6.1 General
You can configure the camera to start a continuous video recording when you turn on the
camera. The recording cannot be stopped.
Note The continuous video recording functionality is configured by a setting in FLIR
Tools, see section 11.10.2 The User interface tab, page 27.
11.7 Freezing the image
11.7.1 General
You can freeze the image.
11.7.2 Figure
11.7.3 Procedure
Note The function of the trigger is configured by a setting in FLIR Tools, see section
11.10.2 The User interface tab, page 27.
#T810170; r. AE/41948/41948; en-US
23