In-truck charger (optional
accessory)
12
12.1 Introduction
Thank you for choosing the FLIR Kx3 series in-truck charger from FLIR Systems.
The in-truck charger is intended to be mounted on a flat surface in the cab, in one of the
equipment lockers, or in another suitable compartment on the fire engine. The in-truck
charger has five ports for cable routing—one through the rear of the metal bracket and
one port on each side of the in-truck charger.
The in-truck charger can also be powered using a standard FLIR Systems power supply,
and has a battery charger located at the lower front of the unit.
#T810170; r. AE/41948/41948; en-US
29