FLIR K33 - Camera Care and Service; Routine Maintenance and Inspection

Maintenance, inspection, and
service
17
The following maintenance and inspection procedures apply.
17.1 Maintenance
After each use:
1. Clean the camera according to section 16.1 Cleaning, page 50.
2. Charge the battery according to section 11.1.1 Charging the battery, page 19.
17.2 Inspection
After each use:
1. Verify the function and integrity of the latch that secures the battery.
CAUTION
Make sure that you do not use a torque value that is more than 80 Ncm on the Torx T20 screw. Dam-
age to the camera can occur if you do not obey this.
2. Inspect the lens for scratches.
3. Inspect the screen for scratches.
4. Inspect the camera body for damage.
5. Verify the function of all buttons and triggers.
6. Inspect the attachment point for the lanyard strap/neck strap, and the attachment point
for the retractable lanyard.
17.3 Service
For contact details to our service departments, use the following link:
http://support.flir.com/service
#T810170; r. AE/41948/41948; en-US
52