User Interface Menus
5
Figure 5.18 Selecting pin-based measurement mode
• Pinless mode: Select this mode when using the pinless sensor (rear of
MR277). See Section 7.5 Pinless Moisture Measurements for more
information.
Figure 5.19 Selecting the pinless measurement mode
• MR12 mode: Select this mode when using the optional MR12 Ball Mois-
ture probe accessory. The MR12 attaches to the RJ jack on the bottom of
the MR277. See Section 7.7 External Ball Moisture Probe for more
information.
Figure 5.20 Selecting the MR12 (optional moisture probe) mode
#NAS100005; r. AL/76939/76957; en-US
16
To Next Page
Loading...
