User Interface Menus
5
5.6 Moisture Modes Menu
The Moisture Mode Menu offers five sub-menus as described below.
Figure 5.16 Opening the Moisture Mode menu
• Material Group selection: This mode is only available when the pinless
mode is selected (below). Select Group 1 through Group 11 depending on
the material under test. See Section 15 Appendices for the Material Group
selection tables that help you select the correct group number.
Figure 5.17 Selecting a Material Group for pin-based moisture measurements
• Pin mode: Select this mode when using an external pin probe. See Sec-
tion 7.6 External Pin Probe Measurements for more information. When the
pins are replaced in a pin probe, if the entire probe is replaced, or to simply
ensure the highest accuracy, please perform a PIN calibration. See the
Settings menu, Section 5.8 (Settings/Device Settings/Reset Options), for
information.
#NAS100005; r. AL/76939/76957; en-US
15
To Next Page
Loading...
