Thermal and Visible Camera Operation
8
8.3 Digital (Visible) Camera
Select the full screen Digital Camera from the menu system: Select button/Im-
age Mode/Digital Camera
.
Figure 8.3 Selecting the Digital Camera image
The Digital Camera lens is located on the back of the meter. Face the lens to-
ward the area of interest and view the image on the display.
Measurement data can be superimposed on the Digital Camera image. From
the menu system use the Custom IGM™ menu to select the measurements
you wish to see on the camera image (Settings/Custom IGM™). Select the
IGM™ Custom option from the Measurement menu (Measurement/IGM™
Custom mode) in order to see all of the parameters, selected in the Settings
menu (Section 5.8), superimposed on the camera image.
When the Laser pointer button
is pressed, the Laser beam appears. Use
the Laser beam and the cross-hairs (‘Center Spot’ selection in the Measure-
ment menu) to target the surfaces under test. The temperature reading repre-
sents the spot targeted by the cross-hairs and Laser pointer.
Note that the Laser is carefully aimed to align with the cross-hairs for easier
identification and targeting of objects and surfaces.
#NAS100005; r. AL/76939/76957; en-US
43
To Next Page
Loading...
