Moisture Measurement Operation
7
Figure 7.12 Selecting the MR12 (optional Ball Moisture probe) mode
• Set Reference Mode
‘Set Reference’ is used to compare measurements to a stored reference
value. This mode applies only to readings taken with the pinless internal
sensor or the external MR12 Ball Moisture probe. The moment the Set
Reference mode is selected, the current reading is offset to zero. Subse-
quent readings will be offset by this same amount, see Section 7.8 Set
Reference Mode for additional information.
Figure 7.13 Selecting the ‘Set Reference’ mode.
#NAS100005; r. AL/76939/76957; en-US
35
To Next Page
Loading...
