FLOWMAX Technologies 120 - Unpacking

REGULATION INSTRUCTIONS
19
B
C
A
3.2 Unpacking
■ The materials (cardboard) used for packing the appliance are fully recyclable.
■ It is recommended that the packing material is only removed prior to installing the water heater. The
manufacturer will not be held responsible for damage caused by incorrect storage of the product.
■ Packing materials (plastic bags, polystyrene, nails, etc.) must not be left within reach of children, in that
these items represent a potential hazard.
A. Place the packed appliance on the
floor (see fig. 1) making sure that the
"up” arrow is facing down. Remove the
staples and open out the four flaps of the
box.
B. Rotate the water heater 180° while
manually supporting it from underneath
C. Lift the box and remove the
protections. Lift the water heater by
grasping the rear part and proceed with
the installation.
STORAGE & HANDLING
Please note that prior to installation the
FLOWMAX water heaters should be
stored in the horizontal position with no
more than three water heaters to a stack;
Ensure that the water heaters are stored
in dry conditions and be aware that the
carton is a two-man lift;
Fig. 1