E119-P
FW_E119-P_M_v0301-03_EN Page 59
Install the new battery as follows:
1. Unpack the new battery and ensure there are
no signs of damage or overheating.
2. Press the battery fully into the battery holder
as shown.
3. Carefully click the back cover into its original
position on the MEM.
7.4 REPLACE SILICA GEL SACHET
A silica gel sachet is not supplied with the product but may have been placed during or after
installation to prevent condensation.
Incompatibility risk
Do not use silica gel in environments where hydrogen fluoride, strong acids and/or strong bases are
to be expected
1. Follow the instructions shown in Section 6.2.3: Opening, assembling and closing the unit[»42], to
gain access to the inside of the housing.
2. Remove old silica-gel sachet from housing and replace with a new dry sachet.
3. Dispose of waste in accordance with (inter)national, manufacturer and plant owner standards
and regulations.
To Next Page
Loading...
