Fluke 112 Calibration Information

Cleaning the Meter
15
Cleaning the Meter
WWarning
To avoid electrical shock or damage to the Meter, never allow water inside the
case. To avoid damaging the housing, never apply solvents to the Meter.
• Periodically wipe the case with a damp cloth and mild detergent. Do not use abrasives or solvents.
• Dirt or moisture in the input terminals can distort meter readings. Clean the terminals as follows:
1. Turn the rotary switch to
OFF and remove the test leads from the terminals.
2. Shake out any dirt that may be in the terminals.
3. Soak a new swab with alcohol. Clean each terminal with the swab.

Fluke 112 Specifications

General

Category	Multimeter
Continuity	Yes
Diode Test	Yes
Display	Digital
DC Voltage Ranges	400.0 mV, 4.000 V, 40.00 V, 400.0 V, 600 V
Resistance Ranges	400.0 Ω, 4.000 kΩ, 40.00 kΩ, 400.0 kΩ, 4.000 MΩ, 40.00 MΩ
Safety Category	CAT III 600 V
AC Voltage Accuracy	±(1.0% + 3)
Battery Type	9 V
DC Voltage Accuracy	±(0.5% + 2 counts)
AC Voltage Ranges	4.000 V, 40.00 V, 400.0 V, 600 V