Fluke 112 Calibration Information

Models 110, 111 & 112
Calibration Information
6
Testing the Fuse (Models 111 and 112)
WWarning
To avoid electrical shock or injury, remove the test leads and any input signals
before replacing the fuse.
Test the fuse as shown below.
Ω
<.5
OK
OK
aej12f.wmf
Figure 1. Testing the Fuse

Fluke 112 Specifications

General

Category	Multimeter
Continuity	Yes
Diode Test	Yes
Display	Digital
DC Voltage Ranges	400.0 mV, 4.000 V, 40.00 V, 400.0 V, 600 V
Resistance Ranges	400.0 Ω, 4.000 kΩ, 40.00 kΩ, 400.0 kΩ, 4.000 MΩ, 40.00 MΩ
Safety Category	CAT III 600 V
AC Voltage Accuracy	±(1.0% + 3)
Battery Type	9 V
DC Voltage Accuracy	±(0.5% + 2 counts)
AC Voltage Ranges	4.000 V, 40.00 V, 400.0 V, 600 V