Insulation Multimeter
Safety Information
3
• Keep fingers behind the finger guards on
the probes.
• Do not exceed the Measurement Category
(CAT) rating of the lowest rated individual
component of a Product, probe, or
accessory.
• Use the Product only as specified, or the
protection supplied by the Product can be
compromised.
• Comply with local and national safety
codes. Use personal protective equipment
(approved rubber gloves, face protection,
and flame-resistant clothes) to prevent
shock and arc blast injury where
hazardous live conductors are exposed.
• Do not work alone.
• Do not apply more than the rated voltage
between the terminals or between each
terminal and earth ground.
• Limit operation to the specified
measurement category, voltage, or
amperage ratings.
• Use Product-approved measurement
category (CAT), voltage, and amperage
rated accessories (probes, test leads, and
adapters) for all measurements.
• Measure a known voltage first to make
sure that the Product operates correctly.
• Use the correct terminals, function, and
range for measurements.
• Measure for hazardous voltage without the
Low-Pass Filter.
• Do not use the Product if it operates
incorrectly.
• Replace the battery when the low battery
indicator () shows to prevent incorrect
measurements.
• Remove the batteries if the Product is not
used for an extended period of time, or if
stored in temperatures >50 °C. If the
batteries are not removed, battery leakage
can damage the Product.
• The battery door must be closed and
locked before you operate the Product.
• Remove all probes, test leads, and
accessories before the battery door is
opened.
• Do not use the Product if it is damaged.
• Disable the Product if it is damaged.
ГК Атлант Инжиниринг – официальный представитель в РФ и СНГ
+7 (495) 109-02-08 sales@bbrc.ru www.bbrc.ru
To Next Page
Loading...
Need help?
General
