Fluke 1653B - Memory Mode Test (1653 B and 1654 B Only)

Electrical Installation Tester
Performance Tests
21
280V
RMS
MAX
280V
RMS
MAX
CA T I
1000V
CA T II
600V
RMS MAX
20V PK
30A
RMS
MAX
20V PK
LO
LO - SENSE
, HI ,
mA
V
1500V PK
MAX
50V PK
MAX
20V PK
20V PK
N
L
PE
L1 L2 L3HES
OUTPUT
Z
L
, Z
GND
,
RCD
HI
LO
HI
LO
METER
METER
5320A MU LTIFUNCTION ELECTRICAL
V
A
COM
INPUT
Fluke 5320A
PE
(L2/Green)
L
(L1/Red)
gad002.eps
Figure 4. Touch Pad Sense Test
Memory Mode Test (1653B and 1654B Only)
Use the following test to verify the proper function of the UUT Memory Mode:
1. Turn the rotary switch to V.
2. Connect the PE and L input jacks of the Tester to the 5320A V, HIΩ, mA~ Output
terminals as shown in Figure 4.
3. Set the 5320A for the Volts function and apply 25 V, 50 Hz to the Tester.
4. Press UUT  to enter Memory Mode.
5. Use < and the  to set the data identity.
6. Press  to save the data.
To recall the saved data:
7. Press  to re-enter Memory Mode.
8. Use < and  to set the data identity.
9. Press  twice to recall the data. The recalled data should match the saved value.