165X
Users Manual
38
• If the data identity has been previously used, the
display will show STO? Press 2 again to store
the data, press 1 to choose another data
identity, press M to exit Memory mode.
Recalling a Measurement
To recall a measurement
1. Press M to enter the Memory mode.
2. Press 3 to enter the Recall mode.
3. Use 1 and the arrow keys(U) to set the data identity.
If no data has been saved, all fields will be dashes.
4. Press 3 to recall the data. The tester display will
revert to the Test mode used for the recalled test
data, however, the N icon still appears,
indicating the tester is still in Memory mode.
5. Press 3 to toggle between the data id screen and the
recalled data screen to check the recalled data id or
to select more data to recall.
6. Press M to exit Memory mode at any time.
Clearing Memory
To clear all memory
1. Press M to enter Memory mode.
2. Press 4. The primary display will show Clr?. Press
4 again to clear all memory locations.
3. Press M to exit Memory mode.
Note
All memory locations are cleared when you clear
memory. Single memory locations cannot be
cleared, but they can be overwritten. See “Storing
a Measurement” earlier in this manual.
To Next Page
Loading...
