165X
Users Manual
40
To upload test results
1. Connect the IR serial cable to the serial port on the
PC.
2. Attach the IR adapter and the device to the tester as
shown in Figure 22. Be sure to align the IR adapter to
the IR port on the tester.
Note
The IR data port is disabled when test leads are
plugged in. Disconnect test leads before
attempting to upload test results.
3. Start FlukeView Forms.
4. Select the form template you want to use by opening
the File menu and selecting New Blank Form.
Highlight the form template in the New Blank Form
dialog box and click OK.
5. Press O to turn on the tester.
6. On the FlukeView Forms Meter menu, select Get
Meter Data to upload the data to the active form. The
Get Meter Data dialog box appears.
7. You can also press the Get Meter Data button to
access the dialog box.
8. Data readings are copied directly into the active form.
Refer to the
FlukeView Forms Documenting Software
Users Manual
for additional information.
Maintaining the Tester
Cleaning
Periodically wipe the case with a damp cloth and mild
detergent. Do not use abrasives or solvents.
Dirt or moisture in the terminals can affect readings.
To clean the terminals
1. Turn the meter off and remove all test leads.
2. Shake out any dirt that may be in the terminals.
3. Soak a new swab with alcohol. Work the swab around
each terminal.
To Next Page
Loading...
Need help?
General
