Fluke 43 - Selecting Probes

Introducing the Fluke 43
Instrument Setup
1
15
Selecting Probes
For standard operation, use the red test lead on input , the black test
lead on COM
and the current clamp on input . If you are using
other test leads or probes, you must change the probe settings accordingly.
1
Open the main
MENU
.
2
3
Select the type of probe you are going to use
on input 1. For all applications in the
Applications Guide, you must use test leads.
4
(for example)
5
Accept the probe settings for
input 1.
The screen closes.
6
Select
PROBES
again.
Select the sensitivity of the current probe you are going to use on input 2.
For all applications in the Applications Guide, use the 80i-500s current probe
and choose
1 mV/A
.
7
Move to the probe settings for input 2.
8
(for the 80i-500s current probe)
9
Accept the probe settings for input 2.
1 m
V
/
A
u
u
INSTRUMENT SETUP
u
PROBES
TEST LEADS
u