Fluke 5725A - Page 207

Index (continued)
3
POWER switch, 3-5
Problems, 2-5, 7-3
—R—
Rack mounting, 2-5
Rear panel features, 3-6
Remote control, 3-3
Replacing the fuse, 6-3
—S—
Selecting line voltage, 2-7
Self diagnostics, 7-3
Service information, 2-5
Setting the output, 3-3
Setting up, 2-3
Signal transformer usage (High Voltage
Amplifier), 4-29
Specifications, 1-7
Standard equipment, 2-3
Standby mode, 3-9, 4-7
Current standby mode, 3-11, 4-7
Voltage standby mode, 3-10, 4-7
Switches
CALIBRATION, 3-7
Line voltage selection, 2-7, 3-7
POWER, 3-5
—T—
Terminals
CHASSIS GROUND, 3-7
CURRENT OUTPUT, 3-5, 3-7
HI, 3-5, 3-7
LOW, 3-5, 3-7
Troubleshooting, 7-3
Fault at power-up, 7-7
Fault when entering current operate, 7-8
Fault when entering current standby, 7-8
Fault when entering voltage operate, 7-8
Fault when entering voltage standby, 7-7
Turning on the 5725A, 3-8
—U—
Unpacking and inspection, 2-3
—V—
Ventilation, clearance needed for, 2-5
Verification, 5-3
Voltage
Output, 3-3
Selecting line, 2-7
Standby, 3-10, 4-7
VOLTAGE MODE indicator, 3-5
—W—
Warm up period, 3-8