Need help?Do you have a question about the Fluke 6500 and is the answer not in the manual?
General| Brand | Fluke |
|---|---|
| Model | 6500 |
| Category | Circuit Tester |
| Language | English |
Information on how to contact Fluke for product information, operating assistance, or service.
Guidelines to avoid possible electric shock or personal injury during tester operation.
Identifies and describes the connectors and controls on the tester's front panel.
Describes the self-test process and the idle screen display upon powering up.
How to adjust the tester's display contrast for better readability.
Procedure to zero the earth bond test lead for accurate resistance measurements.
Procedure to change the factory default access code for security and settings modification.
Critical safety warnings before commencing any testing procedures.
How to immediately stop and make the tester safe during a test.
Steps to start and run an auto-test in either standard or fast mode.
Step-by-step guide to select and run individual manual tests.
How to visually inspect an appliance before electrical testing.
Checks the resistance between the earth pin and exposed metalwork.
Measures the resistance of the insulation between earth and other pins.
Measures leakage current between earth and live/neutral pins.
Measures leakage current between earth and exposed conductive parts.
Verifies fuse and lead continuity by applying a low voltage signal.
Measures power consumption and earth leakage current at mains voltage.
Tests the IEC lead for earth bond resistance, insulation, and continuity.
Measures voltage on the PROBE PELV input to check protective extra low voltage.
Procedures for saving test results and appliance information.
How to view stored factory and user-defined auto-test sequences.
Steps to establish communication between the tester and a printer or PC.
Instructions for cleaning the tester case and leads.
Recommendations for periodic calibration by qualified personnel.
Lists standard and optional accessories with their part numbers.
Details the physical and environmental characteristics of the tester.
Provides detailed technical specifications for various tests.
Specifications for the tester's power-on self-test and mains voltage measurement.
Technical specifications for the Earth Bond test, including ranges and accuracy.
Technical specifications for the Insulation test, including ranges and accuracy.
Technical specifications for the Substitute Leakage Current test.
Technical specifications for the Touch Current test.
Technical specifications for measuring load current during tests.
Technical specifications for measuring load power during tests.
Technical specifications for measuring leakage current during tests.
Technical specifications for the IEC Lead test.
Technical specifications for the PELV test.
To Next Page
