Users Manual
Using the Memory
29
Using the Memory
The tester has a non-volatile memory to save test results
and auto-test sequences.
Saved test results or auto-tests will not automatically be
saved on the compact flash card. The compact flash card
is intended to be used as a backup for the non-volatile
memory. Refer to page 33 for information on how to
download the memory contents to compact flash card.
Beside saving test results and auto-tests you can also
view saved results, delete individual result records, clear
the entire memory and review auto-tests.
Saving Test Results
In the auto-test mode and in the manual single test mode
you can save test results when a test has finished.
In the manual continuous test mode you can save the
displayed test result. The display reverts to the testing
screen after the results have been saved.
Warning
In continuous test mode the test continues
whilst you are saving the result!
Proceed as follows to save the results:
1
MEM
Open the Save result screen and enter
appliance information.
2
GO
Save test results and information.
The Save result screen will present you four fields that
you can enter data into. The data can be inserted via the
keyboard or the Fluke barcode scanner.
Appliance ID
Location
Description
Note
← Mandatory field
← Optional field
← Optional filed
← Optional field
Appliance ID
On pressing
MEM
the Appliance ID field will :
• automatically be incremented by 1 from the last stored
value if you are using numeric only appliance ID
references.
• show the last appliance ID If you are using
alphanumeric ID references.
To Next Page
Loading...
