Fluke 7008 - Page 5

Contents (continued)
iii
9.12.1 Baud Rate ........................................................................... 9-11
9.12.2 Sample Period .................................................................... 9-12
9.12.3 Duplex Mode ....................................................................... 9-12
9.12.4 Linefeed .............................................................................. 9-13
9.13 IEEE-488 Parameters Menu ...................................................... 9-13
9.13.1 IEEE-488 Address .............................................................. 9-13
9.14 Calibration Parameters .............................................................. 9-14
9.14.1 CTO .................................................................................... 9-14
9.14.2 H and L ............................................................................... 9-14
10 Digital Communication Interface ....................................................... 10-1
Digital Communication Interface ............................................................ 10-1
10.1 Serial Communications .............................................................. 10-1
10.1.1 Wiring .................................................................................. 10-2
10.1.2 Setup .................................................................................. 10-2
10.1.2.1 Baud Rate ........................................................................ 10-2
10.1.3 Serial Operation .................................................................. 10-3
10.2 IEEE-488 Communication (optional) ......................................... 10-3
10.2.1 Setup .................................................................................. 10-3
10.2.1.1 IEEE-488 Interface Address ............................................ 10-6
10.2.2 IEEE-488 Operation ............................................................ 10-6
10.3 Interface Commands ................................................................. 10-6
10.4 Power Control Functions ........................................................... 10-7
10.4.1 Heater Control .................................................................... 10-7
10.4.2 Cooling Control ................................................................... 10-7
11 Calibration Procedure ......................................................................... 11-1
Calibration Procedure ............................................................................ 11-1
11.1 Calibration Points ....................................................................... 11-1
11.2
Measuring the Set-point Error .................................................... 11-1
11.3 Computing D
O
and D
G
................................................................ 11-2
11.4 Calibration Example ................................................................... 11-2
12 Maintenance ......................................................................................... 12-1
Maintenance .......................................................................................... 12-1
13 Troubleshooting .................................................................................. 13-1
Troubleshooting ..................................................................................... 13-1
13.1 Troubleshooting ......................................................................... 13-1
13.2 Comments ................................................................................. 13-6
13.2.1 EMC Directive ..................................................................... 13-6
13.2.2 Low Voltage Directive (Safety) ........................................... 13-6