Fluke 8558A - Instrument Setup

Reference Multimeter and 8 ½ Digit Multimeter
Instrument Setup
97
Instrument Setup
Once the Product is on, push  to show the Instrument Setup. Before you
use the Product, use the Instrument Setup menu to set the Product up according
to your preferences. The display shows the Instrument Setup information:
• Model
• Serial Number
• Firmware
Submenus from Instrument Setup are accessed with each softkey (
through ):
•  (Reset Instrument): Push this softkey to reset the Product to the
default settings, except these settings which are retained:
o Line Frequency and Ext. Ref. Clk ( > Instrument Settings)
o All settings under  > Display settings
o All remote settings ( > Remote settings) except that
Emulation defaults to None on power cycle and instrument reset
o Calibration constants
o Zero values including the use of Zero
•  (Instrument Settings): Includes the Display Settings menu, Line
Frequency selection (Auto, 50Hz, 60Hz), and Ext Ref Clk (OFF, 1MHz, or
10MHz).
•  (Remote Settings)
•  (Cal Adjust)
•  (Diagnostics)
Each of these menus can be used to change make changes to the way the
Product is set up. These menus are explained in the next sections.