Reference Multimeter and 8 ½ Digit Multimeter
Features
93
Note
When you use Chart, use a fixed range as Auto range can affect the
data. If there are any measurements in the record that are
overrange, the chart does not include that data point, and the chart
turns red.
The other softkeys in Analyze are
(Chart Only): Shows a Chart (either Trend or Histogram) without showing
the Statistics data. Behavior and control of the Chart is the same as in
(Chart + Statistics). In Chart Only, the chart uses the entire display.
(Limits): Provides a visual indicator of the input relative to settable higher
and lower limits. When either the upper or lower limit is exceeded, the respective
up/down arrow turns red as shown in the screen below:
iei044.png
(Limits Setup): Set the upper and lower limit using and the
numeric keypad. The Upper and Lower limit can be individually turned On or Off.
(Limits): Turns the Limits display ON or OFF.
(Clear Alarm): If a limit shows a red indication, pushing this softkey turns
it back to green until another reading causes that limit to be exceeded.
To Next Page
Loading...
