4 - 34 COMMAND REFERENCE
CALCulate<n>:FILTer[:GATE]:FREQuency:POINts
CALCulate<n>:FILTer[:GATE]:FREQuency:STATe
Syntax:
CALCulate<n>:FILTer[:GATE]:FREQuency:POINts
<numeric_data> | MAXimum | MINimum
CALCulate<n>:FILTer[:GATE]:FREQuency:STATe <Boolean>
<n> [1] | 2
<Numeric_data> 3, 5, 7, .. , 39, 41
Query form:
CALCulate<n>:FILTer[:GATE]:FREQuency:POINts? [MINimum |
MAXimum]
Response:
3 | 5 | .. | 41
If MINimum was specified, 3 is returned.
If MAXimum was specified, 41 is returned.
Query form:
CALCulate<n>:FILTer[:GATE]:FREQuency:STATe?
Response:
0 | 1
0 Filter function turned off.
1 Filter function turned on.
Description:
The CALC<n>:FILT:FREQ:POIN command specifies the width of the filter window,
which can be an odd number of points, varying from 3 points to 41 points in incre-
ments of 2 points. The filter window can be turned on with the CALCulate:FIL-
Ter[:GATE]:FREQuency:STATe command.
The CALC<n>:FILT:FREQ:STAT command switches the calculate function FILTer
on or off. The result of the filter function is stored in M1_n for CALCulate1 and in
M2_n for CALCulate2 dependent on the input source CHn or Mi_n (n = 1, 2, 3, 4).
After a
*
RST command, the filter window width is 19 points and the filter function
is turned off.
Example:
Send
→ CALCulate:FILTer:FREQuency:POINts 21 The width becomes
21 points.
Send
→ CALCulate:FILTer:FREQuency:STATe ON Switches the FILTer
function on.
Front panel compliance:
The CALCulate1 and CALCulate2 commands use the MATH1 and MATH2
features of the CombiScope instrument.
To Next Page
Loading...
