Fluke ProcessMeter 789 Calibration Manual

789/787B
Calibration Manual
34

Static Awareness


Semiconductors and integrated circuits can be damaged by electrostatic
discharge during handling. This notice explains how to minimize damage to
these components.
1. Understand the problem.
2. Learn the guidelines for proper handling.
3. Use the proper procedures, packaging, and bench techniques.
Follow these practices to minimize damage to static sensitive parts.
 Warning
To prevent electric shock or personal injury. De-energize
the product and all active circuits before opening a
product enclosure, touching or handling any PCBs or
components.
• Minimize handling.
• Handle static-sensitive
parts by non-conductive
edges.
• Do not slide static-
sensitive components
over any surface.
• When removing plug-in
assemblies, handle only
by non-conductive
edges.
• Never touch open-edge
connectors except at a
static-free work station.
• Keep parts in the original
containers until ready for
use.
• Use static shielding
containers for handling
and transport.
• Avoid plastic, vinyl, and
Styrofoam
®
in the work
area.
• Handle static-sensitive
parts only at a static-
free work station.
• Put shorting strips on
the edge of the
connector to help
protect installed static-
sensitive parts.
• Use anti-static type
solder extraction tools
only.
• Use grounded-tip
soldering irons only.

Fluke ProcessMeter 789 Specifications

General

Diode test	Yes
Frequency range	0 - 19.999 kHz
AC current range	0 - 1 A
AC voltage range	0 - 1000 V
Resistance range	0 - 40000000 Ω
Resolution (AC voltage)	0.1 mV
Dimensions (WxDxH)	100 x 203 x 50 mm

Weight and Dimensions

Weight	610 g