Meter and Source Features
9
A X: On/off key.
B R S T: Softkeys, which provide functions related to
the current display. The funtions are displayed above
the keys.
C M: Selects the meter’s measurement mode. To enter
setup mode, hold down
M for 4 seconds. See page 12.
D LCD display.
E Input port with interchangeable connector adapter. See
page
16.
F USB port for uploading test records to a PC. See page 33.
G A: Selects auto wavelength mode. The AUTO LED
lights. Press
Z to change the wavelength. The
wavelength LEDs indicate the wavelength. See page 14.
H M: Switches between continuous wave and 2 kHz
modulated output signals. The CW/2 kHz LED lights if
the output is continuous. It blinks if the output is
modulated. See page
14.
Also enables or disables auto power-off. See page 12.
I I: Selects FindFiber mode. The ID LED lights if the
source is in FindFiber mode. See page 20.
J The LOW BATTERY LED blinks continuously if the
battery is low. The LED blinks occasionally if auto power-
off is disabled. See page
12.
K Output port with SC adapter.
To Next Page
Loading...
