SimpliFiber Pro Meter and Test Kits
Users Manual
12
Setting User Preferences
For the meter:
1
To enter setup mode, hold down M for 4 seconds.
2
To scroll through the setup items (Table 3), press M. To
change settings, press R D.
3
To exit setup mode, press M until the meter is in the
desired test mode.
For the source:
If auto power-off is enabled, the source turns off after 30
minutes if no keys are pressed.
To disable or enable auto power-off, hold down
M for 4
seconds.
•
If auto power-off is enabled, all LEDs turn on for 3
seconds.
•
If auto power-off is disabled, all LEDs blink for 3 seconds
and the LOW BATTERY LED blinks occasionally.
To Next Page
Loading...
