SimpliFiber Pro Meter and Test Kits
Users Manual
30
Figure 12. Loss Measurement Display
ffl17.eps
A The wavelength being measured.
B Indicates the meter is in auto wavelength mode.
C The loss measurement. If the loss measurement is blinking,
the loss is negative and less than -1.0 dB. See “If Loss is
Negative” on page 31.
D The reference value.
E Pressing T SET REF saves the measured power level as the
reference.
F Pressing R SAVE saves the measurement. If the source was
automatically switching wavelengths, the meter saves
measurements for all wavelengths in one record.
To Next Page
Loading...
