Fluke Ti30 - File

File
Create a New Folder
Creates a new folder, naming it according to the date and time. The name is highlighted and
editable, so you may rename it according to your own naming conventions.
Note:
You will not see the new folder unless you are in Session View, with the tree
structure found on the left side of the screen.
Download a Session from Imager
With the Ti30 imager connected through the USB connection on the computer, allows for
the download of images from the imager to the computer for storage, analysis and report
creation using InsideIR.
Upload a Session to Imager
Creates a new folder, naming it according to the date and time. The name is highlighted and
editable, so you may rename it according to your own naming conventions.
Set Date and Time in Imager
Creates a new folder, naming it according to the date and time. The name is highlighted and
editable, so you may rename it according to your own naming conventions.
Display Imager Information
Product-specific information about each Ti30 imager you have used with a specific
computer. This is useful when contacting the factory for service information. It is also useful
to use the name of the individual units at the highest level in your directory structure,
keeping all images stored by a single unit in the same folder.
Clear Images in Imager
Creates a new folder, naming it according to the date and time. The name is highlighted and
editable, so you may rename it according to your own naming conventions.
Compact Database
Creates a new folder, naming it according to the date and time. The name is highlighted and
editable, so you may rename it according to your own naming conventions.
Exit
Quits the application.
Jan 31st, 2005 - 80 -