Hooking Up the Docking Station
Connect the power adapter plug into the Docking Station’s power jack.
Connect the power plug to a power outlet. (Depending on the power requirements in
your country you may need to use one of the several adapters provided that matches the
power plug to the local power outlet.)
Figure 33. The Power Cord
Find the USB port on your computer. Look for this symbol on your computer.
Locate the USB communication cord permanently attached to the docking station. (The
USB communication cord is equipped with an USB connector.)
Insert the USB connector on the cord to the USB port on your computer (see Figure
18).
Figure 34. Connecting the USB Connector to the USB Port
Dock the imager in the docking station.
The first time you place the imager in its docking station and press the SYNC button
with the docking station connected, your computer's operating system will detect new
hardware and locate the correct communication driver. Your computer will automatically
launch its own driver installation program. Follow the installation instructions. You will
only have to go through this process once.
Jan 31st, 2005 - 40 -
To Next Page
Loading...
