9
Physical Characteristics
M
The M key lets you access these phone numbers, settings, and tests:
•
Contacts: A phonebook of nine stored numbers for the speed dialing function. See
"Dialing and Storing Numbers in Memory" on page 13, "Program Speed Dialing Numbers"
on page 13, and "Dialing a Number with the Speed Dial Function" on page 14.
The number in memory location 9 is the numbers for the ANAC function. See "Visual ANAC
Mode" on page 15.
•
Call Log: A list of phone numbers for the last 10 calls that the test set made or received.
See "Dialing a Number from the Call Log" on page 15.
•
Digit Grab: Shows you the digits dialed by another device. See "DTMF Digit Grabbing"
on page 15.
•
SmartTone: Lets you use an inductive probe to find telephone lines. See "Using the
Toner" on page 17.
•
EditContact: Lets you edit numbers in the phonebook. See "Program Speed Dialing
Numbers" on page 13.
•
TDR : Lets you change the Line Verification and VOP settings for the TDR. See "Line
Verification" on page 16 and "VOP" on page 17.
•
Settings: Lets you change settings for the backlight timeout (page 21), handset and
speaker volume (page 22), tone/pulse mode (page 20), pause duration (page 20), flash
duration (page 20), default mode for the speakerphone (page 20), and the test set timeout
(page 21). You can also reset the test set to factory defaults (page 23).
Table 2. Keys (continued)
To Next Page
Loading...
