EasyManuals Logo

Fluke TS54-A-09-TDR User Manual

Fluke TS54-A-09-TDR
36 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #6 background imageLoading...
Page #6 background image
2
TS54TDR PRO Test Set
Users Guide
Fluke Networks operates in more than 50 countries
worldwide. For more contact information, go to
our website.
Symbols
The following symbols are used on the test set or in the
manual:
WSafety Information
W
WarningX
To avoid possible fire, electric shock, or
personal injury:
Do not use the test set if it is damaged. Before you
use the test set, inspect the case. Look for cracks or
missing plastic. Pay particular attention to the
insulation surrounding the connectors.
Do not use around explosive gases or vapors, or in
a damp or wet environment when hazardous
voltage is present.
Do not connect the test set to lines that have more
than 140 V dc.
The test set meets IEC Measurement Category I.
CAT I equipment is designed to protect against
transients in equipment on circuits not directly
connected to MAINS. Under no circumstances
should the test leads of the test set be connected
to any CAT II, CAT III, or CAT IV rated circuit.
Do not use test leads if they are damaged. Examine
the test leads for exposed metal and damage to
the insulation. Make sure the wear indicator on the
cords does not show. The wear indicator is the
white layer below the outer, braided layer. Verify
the continuity of the test leads. To replace the test
leads, see page 28.
Measure a known DC test voltage before you use
the Product to test an active phone line.
The IP rating applies to non-operation of the
Product.
Inspect the internal Tip and Ring terminals under
the battery door. Before you use the test set, make
sure the terminal area is dry and clean. If you
cannot clean the terminal area, return the product
to Fluke Networks for cleaning.
Make sure that the test leads are clean and dry
before you use the test set.
Do not use the headset in environments where
transient voltages can exceed 300Vpk.
Do not connect the test set to voltages higher than
the maximum specified by the Measurement
Category (CAT) rating of the lowest-rated
individual component of the test set, test leads, or
accessory.
W
Warning: Risk of personal injury. See the
manual for details.
Caution: Risk of damage or destruction to
equipment or software. See the manual for
details.
X
Warning: Risk of electric shock.
Consult the user documentation.
Conforms to relevant Australian EMC
requirements.
)
Certified by CSA Group to North American
safety standards.
P
Conformite Europeene. Conforms to the
requirements of the European Union and the
European Free Trade Association (EFTA).
40 year Environment Friendly Use Period
(EFUP) under China Regulation -
Administrative Measure on the Control of
Pollution Caused by Electronic Information
Products. This is the period of time before any
of the identified hazardous substances are
likely to leak out, causing possible harm to
health and the environment.
T
Double Insulated - does not require
connection to earth ground.
~
Do not put products containing circuit boards
into the garbage. Dispose of circuit boards in
accordance with local regulations.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Fluke TS54-A-09-TDR and is the answer not in the manual?

Fluke TS54-A-09-TDR Specifications

General IconGeneral
BrandFluke
ModelTS54-A-09-TDR
CategoryTest Equipment
LanguageEnglish

Related product manuals