28
TS54TDR PRO Test Set
Users Guide
Replacing the Belt Clip
You can replace the belt clip if it is damaged. To order a
replacement belt clip, contact your local Fluke
Networks authorized distributor.
To replace the belt clip:
Refer to Figure 7.
1
Use a Phillips screwdriver to remove the two
screws that attach the belt clip to the test set.
Remove the belt clip.
2
Put the screws into the plate on the new belt clip.
3
Put the end of the plate into the slot as shown in
Figure 7 before you align the screws with the holes
in the test set.
4
Tighten the screws.
WCaution
Do not over-tighten the screws for the belt
clip. If you do, you can cause damage to the
screw holes.
GOL06.EPS
Figure 7. How to Remove and Install the Belt Clip
Replacing the Belt Clip Protector
The belt clip protector prevents damage to the belt clip
if you drop the test set. You can replace the protector if
it is damaged:
1
Remove the belt clip as described in the previous
section.
2
Remove and install the protector as shown in
Figure 8.
GOL09.EPS
Figure 8. How to Remove and Install
the Belt Clip Protector
Replacing the Test Leads
You can replace a worn out or damaged test lead. To
get a replacement test lead, contact your local Fluke
Networks authorized distributor.
WWarningX
Read all instructions completely and
understand possible hazards to end user if
repairs are not performed properly.
Before you remove the battery door,
disconnect the test leads from the line.
Install only test leads that are supplied by
Fluke Networks for your model of the test
set.
To Next Page
Loading...
