134
2. Do not forget to take a high-quality
bike lock with you on the ride so you
can park and lock your FLYER to an
immovable object. Separately lock
the components that are fastened
with quick release fasteners (e.g. the
front wheel) as required. This will pre
-
vent theft of these add-on parts.
3. The battery on your FLYER is se
-
cured by the ABUS Plus system, a
particularly safe and durable locking
system, preventing it from being re
-
moved without permission.
10. After a fall
Have the vehicle and all components checked
for changes, damage, rm attachment and cor
-
rect function by a FLYER specialist retailer. This
may, in particular, include dents and cracks in the
frame and fork, bent components and parts such
as the handlebars or a shifted or turned seat.
Inspection by a FLYER specialist retailer must
cover the following main points:
• Carefully check the frame and fork. Deforma
-
tions can usually be detected when looking at
surfaces from different angles.
• Are the seat, seat post, stem and handlebars
still in their correct positions? When this is not
the case, do NOT move the components back
from their changed position before loosening
the relevant screw connection. It is essential
to adhere to the prescribed fastening torque.
Values and information are provided in Chapter
20.2 and in the "Quick release fastener" chap
-
ter (11.1).
• Check whether both wheels are correctly and
rmly attached to the frame and fork, that both
the front and rear wheels rotate freely and that
the rim runs straight past the brakes without
snagging. The tyres must not touch the brakes.
• Check that both brakes are operating fully.
• Do not set off again without having checked
that the chain is sitting securely on both the
front chain wheel and rear sprockets. It must
be engaged fully with the cogs. If you set off
and the chain jumps off a cog you may fall, at
the risk of very severe injury.
• Check whether the display of the FLYER
e-bike shows a fault message or a warning.
Do not drive your FLYER when a warning is
displayed. Immediately contact your FLYER
specialist retailer.
• Check that the display and the battery are un
-
damaged. Do not ride your FLYER if there are
any noticeable changes (cracks, scratches,
etc.). Have all parts and functions rst checked
by your FLYER specialist retailer.
If you notice any changes to your bicycle, DO
NOT continue cycling. Do not retighten any loose
parts without rst checking them and always use
a torque wrench. Take the FLYER to your FLYER
specialist retailer, describe the fall to them and
have the bicycle checked out!
There is a risk that humidity or water
may penetrate the motor if the housing
of your battery is cracked. This may lead
to short circuits or electrical shocks. Im
-
mediately stop using the battery in this
case and contact your FLYER specialist
retailer.
Do not charge the battery.
To Next Page
Loading...
Need help?
General
