Website
25
Voltage sensor (FS-CVT01)
i-BUS2 Series Sensor Connection Diagram
FS-iBS01
FGr4B
Notes:
1. The i-BUS2 series sensors are only compatible with AFHDS 3 enhanced version receivers. Take the FS-iBS01
sensor connection diagram as an example. The method for connecting other i-BUS2 sensors is the same.
2. The i-BUS2 series sensor must be connected to the New Port of the receiver, and set the New Port interface
protocol to i-BUS2 via [RX SET]>[Receiver Interface Protocol].
Note: Please refer to the FS-iBS01 manual for more details.
i-BUS2 Optical Perception Sensor(FS-iBS01)
•