FlySky Noble NB4+ - 8.14 Firmware Update; 8.15 Factory Reset; 8.16 About Noble NB4+

Website
58
7.12RangeTest
7.13BVDVoltageCalibration









 
 
 


 
󽗉
•


 




Note: This function is not available for classic version receivers. Pay attention to
correctly connect the BVD cable to the anode and cathode terminals of the battery.
The connection diagram is as follows.
BVD



Note: please refer to the voltage value of multimeter for
calibration.
 

 󾖶󾖶󾖶󾖶

 󾖶󾖶

Note: When not adjusted, the [Battery voltage] value is
displayed the voltage value in realtime, if set, the edited value
is displayed.