Quick Start
FS-T1001 Media Recorder -
7
Dismounting from a Camera
Remove a battery from FS-T1001:
1. Press in the V-lock release lever and slide the battery up
and off the unit.
2. Remove FS-T1001 from the camera.
1. Unscrew the dock thumbscrews from the camera.
2. Then, press the camera's V-lock release lever and
slide the FS-T001 up and off the camera.
Connecting FS-T1001 to Camera's HD-SDI Port
FS-T1001 ships with an HD-SDI compatible 75-ohm BNC cable.
To connect the camera and FS-T1001, follow these steps:
1. Locate the HD-SDI port on the camcorder.
Ensure that the HD-SDI output port on the camera is
enabled and outputting a valid HD signal. Consult the
camcorder's user manual for additional information.
2. Connect one end of the BNC cable to the camera's HD-
SDI output port.
3. Connect the other end of the BNC cable to the HD-SDI
in port on the FS-T1001, see illustration on page 5.
NOTE: Utilize the included velcro cable strap to restrain
the SDI cable to the FS-T1001's cable routing latch.
To Next Page
Loading...
