Quick Start
FS-T1001 Media Recorder -
9
Setting Up FS-T1001 for Use
Once FS-T1001 has been attached to camera and media has been
inserted:
1. Power on FS-T1001 by pressing the tactile power button.
The FS-T1001 OLED screen immediately lights. A few
seconds later the FS-T1001 boot-up screen appears.
If there is no media in the FS-T1001, the following system
message appears on the FS-T1001 display:
When valid SxS media is inserted, the following
information appears on the FS-T1001 display. (NOTE: after
media has been inserted, press the HOME button to
continue).
CHANGE MEDIA
INSERT NEW CARD
BEFORE EXITING
HOME
To Next Page
