FS-T1001 Menus
FS-T1001 Media Recorder -
27
TC SET
Used to preset the TC (timecode) value on FS-T1001. This value is
available for use by the FS-T1001 immediately after exiting
TC
SET.
Using the TC SET Value
• EXT TC – preset TC value is not used.
•
FREE RUN - preset TC value continuously increments.
•
REGEN - preset TC value is not used.
•
REC RUN – preset TC value is used as the start value for a
new recording.
For more information see
HQ 1080i
1440 - Sets the HQ (35Mb/s) frame size to 1440x1080
1920 - Sets the HQ (35Mb/s) frame size to 1920x1080
TIMECODE on page 22.
Default is
00:00:00:00.
UB SET
Use to preset the UB (user bit) value for recordings.
Professional applications employ user bits to assist in post
production. For example, when multiple cameras are used during a
shoot, each FS-T1001 has a unique UB setting that identifies it and
the camera it serves. Later, the user bits are used to determine
which camera recorded the video clip..
Default is
00:00:00:00.
TC MODE
Use to set the timecode mode to either DROP frame or NON-
DROP frame (60Hz mode only). When using EXT TC mode this
setting has no effect because the FS-T1001 follows the timecode
mode within the incoming RP188 timecode in the HD-SDI stream.
To Next Page
Loading...
