FS-T1001 Menus
- FS-T1001 Media Recorder
22
• SP MODE - Sets the record bit rate to 25Mb/s (MP@H-14)
record mode in the XDCAM EX format.
HD SDI Input for SP Mode
See the supported frame rates in the specification section of
this manual.
Record Modes
For both record modes the standard (50/60Hz) and the frame
rate will follow that of the source. It is not possible for frame
rate conversion, standards conversion, scaling or
interlacing/deinterlacing.
HQ 1080i
• 1440 - Sets the HQ (35Mb/s) frame size to 1440x1080
•
1920 - Sets the HQ (35Mb/s) frame size to 1920x1080
TIMECODE
• EXT TC - The recorded timecode comes from the RP188
timecode in the HD-SDI input stream.
•
FREE RUN - The timecode recorded comes from the internal,
constantly incrementing free run timecode generator in the
FS-T1001. It is possible to set the TC value using the TC Set
function in the setup menu.
•
REC-RUN - The timecode recorded comes from the internal
timecode generator in FS-T1001. Timecode only increments
when a recording is in process. The first frame of a new
recording will have a TC value +1 from the previous recording.
•
REGEN - The timecode recorded comes from the internal
timecode generator on FS-T1001. Timecode only increments
when a recording is in process. The first frame of a new
recording will have a TC value +1 from the last recording on
the media.
FREE RUN, REC-RUN and REGEN record modes ignore the
RP-188 timecode in the incoming HD-SDI stream. These
modes are useful when the RP-188 timecode in the HD-SDI
stream is not desired or the source does not support RP-188
timecode.
To Next Page
Loading...
