Focusrite Clarett 2Pre - Page 10

10
When mixing, you can connect an additional pair of reference monitor speakers to
LINE OUTPUTS 3 and 4 allowing you to check your mix on different types of speaker. By default,
these outputs do not carry the same stereo signal as LINE OUTPUTS 1 and 2. If you wish, you can use
Focusrite Control to route the same stereo signal feeding LINE OUTPUTS 1 and 2 to these outputs.
Main
Monitor
Speakers
Additional
Monitor
Speakers
IMPORTANT:
LINE OUTPUTS 1 and 2 incorporate “anti-thump” circuitry that protects your speakers
if the Clarett 2Pre is turned on while the speakers (and amplier if used) are connected
and active.
LINE OUTPUTS 3 and 4 do not have this circuitry.
If you’re using additional speakers connected to these outputs, we recommend you
power your Clarett 2Pre on rst,
then turn on the speakers or power amplier. But get
into the habit of following the general rule in any case - it is
always good audio practice
to turn on a speaker system of any kind
after turning on the equipment feeding it.