EasyManua.ls Logo

Force 5100ex - User Manual

Force 5100ex
64 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
5100ex Calibration Manual
Firmware Version
3.8

Table of Contents

Questions and Answers

  • C
    Colleen SimpsonAug 11, 2025
    What to do if Force 5100ex shows 'Value above max'?
    • S
      Shelby WilliamsAug 11, 2025
      If the Force Controller displays 'Value above max,' it means the device recorded more than 200,000 pulses, potentially due to excess noise, connection to a digital communication circuit, or driving too far. To resolve this: * Check the wiring and connections of the speedometer cable. * Ensure the Speedometer Type is correctly configured. * Reduce the Low Trip Point. * Increase the High Trip Point.
  • G
    Gary WestAug 26, 2025
    Why does my Force Controller say 'Value below min'?
    • H
      huntdavidAug 27, 2025
      If your Force Controller displays 'Value below min,' it indicates that the device recorded less than 5000 pulses. This can be caused by a disconnected or intermittent speedometer signal, or not driving far enough. To fix this issue: * Check the wiring and connections of the speedometer cable. * Ensure the Speedometer Type is set correctly. * Increase the Low Trip Point. * Decrease the High Trip Point.

Force 5100ex Specifications

General IconGeneral
BrandForce
Model5100ex
CategoryController
LanguageEnglish