5100ex Calibration Manual
Description of Calibration Values
3
Descriptions of Calibration Values
This section describes each setting in the Calibration Menu in detail.
Config
The Config menu allows you to set vehicle-wide settings, the supervisor access and clear codes,
the vehicle’s name, its valve frequencies, and enabled output modes.
Settings
The settings submenu allows you to export or import calibration settings to and from a
USB flash drive. It also allows you to restore the 5100ex to its default settings.
Import Settings
The Import Settings menu item allows you to import all your configuration
settings from a USB flash drive. See page 52 for a step-by-step guide on
importing calibration settings.
Export Settings
The Export Settings menu item allows you to export all your configuration
settings to a USB flash drive. See page 50 for a step-by-step guide on exporting
calibration settings.
Restore Defaults
The Restore Defaults menu item will restore the 5100ex Calibration Settings to
their factory defaults. When the button is pressed a confirmation box will appear,
Press OK to Restore Defaults or CANCEL to close the confirmation box without
upgrading the system.
Upgrade Firmware
The Upgrade Firmware menu item allows you to upgrade your 5100ex to a new version
of firmware located on a USB flash drive. See page 32 for a step-by-step guide on
upgrading firmware.
Access Code
The Access Code menu item allows you to change the supervisor code required to enter
the Calibration Menu. This code should not be set to the same value as the data clear
code. The default value is 00000000.
Clear Code
The Clear Code menu item allows you to change the code required to clear onboard data
totals. This code should not be set to the same value as the supervisor access code. The
default value is 31415926.
Screen Power Switch
The Screen Power Switch menu item allows you to enable or disable the Screen Power
Switch that displays on boot. When enabled, the user will have to press a button on
screen before they can run outputs. The default value is Enabled.
Truck Name
The Truck Name menu item changes the descriptive name given to the vehicle. This
name is used in event logging. The default value is TRUCK1.
Application Mode
The Application Mode menu item selects the application modes that will be available to
the driver. The available options are Granular, Gran/Dir 1 Lane, Gran/Dir 3 Lane, Direct
1 Lane, and Direct 3 Lane. The default value is Granular.
To Next Page
Loading...