5100ex Calibration Manual
First Use Guide
1
First Use Guide
The first time you configure your 5100ex, you will need to complete the following steps to ensure
that your vehicle runs at optimum efficiency:
Step: Page Number:
1. Configure your system-wide options. 3
2. Calibrate your ground speed sensor. 5
If you use granular systems, also complete the following steps:
Step: Page Number:
3. Calibrate your auger minimum and maximum
settings.
8
4. Define your granular material settings. 10
5. Calibrate each granular material’s displacement
and full speed displacement settings.
11
If you use prewet systems, also complete the following steps:
Step: Page Number:
6. Calibrate your prewet minimum and maximum
settings.
16
7. Define your prewet material settings. 16
8. Calibrate the prewet material’s displacement and
full speed displacement settings.
16
If you use direct systems, also complete the following steps:
Step: Page Number:
9. Choose your direct type(s). 18
10. Configure your direct output connector setting. 19
11. Calibrate your direct minimum and maximum
settings.
19
12. Define your direct material settings.
Error!
Bookmark not
defined.
13. Calibrate the direct material’s displacement and
full speed displacement settings.
20
14. Repeat for each direct type.
If you use event logging, also complete the following steps:
Step: Page Number:
15. Follow the steps outlined in the Event Logging
section, depending on whether you use
PreCise™ MRM or AVL event logging.
28
To Next Page
Loading...
Need help?
General