5100ex Calibration Manual
Description of Calibration Values
25
The Hoist Down menu item adjusts the limit percentage for the hoist down
output.
Auger
The Auger menu item adjusts the limit percentage for the auger output. When
the auger output is being limited the prewet output will be adjusted as well.
Alarms
The Alarms menu allows you to configure buzzer settings for the various errors and warnings.
Auger
The Auger sub menu allows you to configure buzzer settings for the auger errors and
warnings. If Config → Application Mode is set to Direct 1 Lane or Direct 3 Lane, this
menu will be disabled.
Feedback
The Feedback menu item adjusts the buzzer setting for the auger feedback error.
The options are Silent, Single Chirp, Single Beep, and Solid Tone. The default
value is Single Beep.
Auger Open
The Auger Open menu item adjusts the buzzer setting for the auger open loop
default error. The options are Silent, Single Chirp, Single Beep, and Solid Tone.
The default value is Single Beep.
Range
The Range menu item adjusts the buzzer setting for the auger range error. The
options are Silent, Single Chirp, Single Beep, and Solid Tone. The default value
is Single Chirp.
Low Material
The Low Material menu item adjusts the buzzer setting for the low material
warning. The options are Silent, Single Chirp, Single Beep, and Solid Tone. The
default value is Single Beep.
Conveyor Stall
The Conveyor Stall menu item adjusts the buzzer setting for the conveyor stall
error. The options are Silent, Single Chirp, Single Beep, and Solid Tone. The
default value is Single Beep.
Two Position Gate
The Two Position Gate menu item adjusts the buzzer setting for the gate sensor
error and the gate position error. The options are Silent, Single Chirp, Single
Beep, and Solid Tone. The default value is Single Beep.
To Next Page
Loading...