EasyManua.ls Logo

Ford S-MAX - Programming the Transmitter

Ford S-MAX
348 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
The LED on the transmitter flashes green
or red for about two seconds. This
indicates the signal was not transmitted
correctly. Repeat the transmission.
The LED on the transmitter illuminates
orange for about two seconds before
showing green or red. This indicates the
transmitter batteries are weak and should
be changed.
The LED on the transmitter flashes orange
for about 5 seconds. This indicates that
the signal was not transmitted. The
transmitter batteries are discharged and
should be changed as soon as possible.
Changing the remote control
battery
Make sure that you dispose of old batteries
in an environmentally friendly way. Seek
advice from your local authority regarding
recycling.
1. Insert a screwdriver or other suitable
tool into the slot on the back of the
remote control, and unscrew the
compartment cover.
CAUTION
Do not touch the battery contacts or
the printed circuit board with the
screwdriver.
2. Carefully prise out the battery.
3. Install a new battery (3.3V type
CR1-3N) with the + facing upwards.
4. Re-assemble the remote control.
Programming the transmitter
Further transmitters may be used with the
remote system, please consult your dealer.
Up to a maximum of 3 separate remote
controls may be added. When adding extra
transmitters these must be programmed
separately.
Note: The heater must be switched off
during programming.
Note: The programming procedure may be
repeated as often as is required. The oldest
programmed transmitter will be deleted
each time.
1. Install the battery in the new
transmitter.
2. Turn off the power to the receiver by
removing fuse F32 from the engine
compartment fuse box. See Fuse
Specification Chart (page 222).
3. Wait for at least 5 seconds.
4. Reconnect power to the receiver by
replacing the fuse, and press the OFF
button on the new transmitter within
5 seconds until the LED light turns off.
5. The new transmitter is now
programmed.
Fuel operated heater (depending
on country)
WARNING
The fuel operated heater must not
be operated at filling stations, near
sources of combustible vapors or
dust or in enclosed spaces.
124
Galaxy/S-MAX (CA1) Vehicles Built From: 25-11-2013, Vehicles Built Up To: 18-12-2014, CG3533en enGBR, Edition date: 11/2013, Second Printing
Climate Control

Table of Contents

Other manuals for Ford S-MAX

Related product manuals