Ford S-MAX - Headlamp Washers; Checking the Wiper Blades; Changing the Wiper Blades; Windshield Wiper Blades

HEADLAMP WASHERS
The headlamp washers will operate with
the windshield washers when the
headlamps are on.
Note: To stop the washer fluid reservoir
emptying quickly, the headlamp washers
will not operate every time that you use the
windshield washers.
CHECKING THE WIPER
BLADES
Run the tip of your fingers over the edge of
the blade to check for roughness.
Clean the wiper blade lips with water
applied with a soft sponge.
CHANGING THE WIPER
BLADES
Windshield wiper blades
CAUTIONS
Set the windshield wipers in the
service position to change the wiper
blades.
CAUTIONS
You can use the service position in
winter to provide easier access to the
wiper blades for freeing them from
snow and ice. Make sure that the outside
of the windshield is free from snow and ice
before using the wipers.
Note: The windshield wiper blades are
different lengths. See Technical
Specifications (page 54). If you install
wiper blades of the wrong length, the rain
sensor may not work correctly.
Set the windshield wipers in the service
position.
Switch off the ignition and move the wiper
lever to position A within three seconds.
Release the lever when the windshield
wipers have moved to the service position.
Lift the wiper arms.
52
Galaxy/S-MAX (CA1) Vehicles Built From: 25-11-2013, Vehicles Built Up To: 18-12-2014, CG3533en enGBR, Edition date: 11/2013, Second Printing
Wipers and Washers