Protective capA
Pressure relief valveB
HoseC
Orange capD
Bottle holderE
Pressure gaugeF
Power plug with cableG
Compressor switchH
LabelI
Bottle lidJ
Sealant bottleK
1. Open the lid of the tire repair kit.
2. Peel off the label I showing the
maximum permissible speed of
80 km/h (50 mph) from the casing and
attach it to the instrument panel in the
driver’s field of view. Make sure the
label does not obscure anything
important.
3. Take the hose C and the power plug
with cable G out of the kit.
4. Unscrew the orange cap D and the
bottle lid J.
5. Screw the sealant bottle K clockwise
into the bottle holder E fully tight.
6. Remove the valve cap from the
damaged tire.
7. Detach the protective cap A from the
hose C and screw the hose C firmly
onto the valve of the damaged tire.
8. Make sure that the compressor switch
H is in position 0.
9. Insert the power plug G into the cigar
lighter socket or auxiliary power socket.
See Cigar Lighter (page 138). See
Auxiliary Power Points (page 138).
10. Start the engine.
11. Move the compressor switch H to
position 1.
12. Inflate the tire for no longer than
seven minutes to an inflation pressure
of minimum 1.8 bar (26 psi) and a
maximum of 3.5 bar (51 psi). Move
the compressor switch H to position
0 and check the current tire pressure
with pressure gauge F.
13. Remove the power plug G from the
cigar lighter socket or auxiliary power
socket.
14. Quickly unscrew the hose C from the
tire valve and replace the protective
cap A. Fasten the valve cap again.
15. Leave the sealant bottle K in the
bottle holder E.
255
Galaxy/S-MAX (CA1) Vehicles Built From: 25-11-2013, Vehicles Built Up To: 18-12-2014, CG3533en enGBR, Edition date: 11/2013, Second Printing
Wheels and Tires
To Next Page
Loading...
