Note: When fitting the headlamp, make
sure that you reconnect the electrical
connector properly.
Note: When fitting the headlamp, make
sure that you fully engage the headlamp in
the lower fixing point.
Note: When fitting the headlamp, make
sure that the front screw is located in the
headlamp molding before you install it.
Note: When fitting the headlamp, tighten
the front screw first and then the rear screw.
CHANGING A BULB
WARNINGS
Switch the lights and the ignition off.
Let the bulb cool down before
removing it.
Have Xenon bulbs changed by a
properly trained technician. There is
a risk of electric shock.
CAUTIONS
Do not touch the glass of the bulb.
Only fit bulbs of the correct
specification. See Bulb
Specification Chart (page 73).
Note: The following instructions describe
how to remove the bulbs. Fit replacements
in the reverse order unless otherwise stated.
Headlamp
Note: Remove the covers to gain access to
the bulbs.
Direction indicatorA
Headlamp main beamB
Headlamp dipped beamC
Cornering lampD
Direction indicator
1. Remove the headlamp. See
Removing a Headlamp (page 64).
2. Turn the bulb holder anti-clockwise
and remove it.
3. Gently press the bulb into the bulb
holder, turn it anti-clockwise and
remove it.
65
Galaxy/S-MAX (CA1) Vehicles Built From: 25-11-2013, Vehicles Built Up To: 18-12-2014, CG3533en enGBR, Edition date: 11/2013, Second Printing
Lighting
To Next Page
Loading...
